UAUT 105 - Light Line Maintenance

1. Perform a cooling system flush 
2. Perfrom an automatic transmission fluid flush 
3. Perform a full brake job 
4. Perform a rear axle remove and replace (R&R)
5. Perform a CV axle R&R 
6. Demonstrate knowledge of Tire Pressure Monitoring Systems (TPMS) and perform basic diagnosis on them
7. Demonstrate tire wear diagnosis and perform a tire dismount, repair, remount, and balance 
8. R&R a water pump and perform a coolant pressure test

1. Safety 
   1. Work habits 
   2. Material Safety Data Sheets (MSDS) 
   3. Environmental Protection Agency (EPA) 
   4. Regulations 
   5. Occupational Safety Health Adminstration (OSHA) regulations  
   6. Fire extinguishers and exits 
2. Engine Mechanicals Systems 
   1. Engine mechanical theory 
   2. Cooling system 
      1. Theory and operation
      2. Water pump and thermostat, R&R 
      3. Pressure test and operational checks 
   3. Exhaust system inspection 
   4. Timing belt and chain inspection 
3. Transmission and Driveline Systems 
   1. Automatic transmission and transaxle 
      1. Seal and gasket leaks, inspection and replacement 
      2. Linkage adjustment and repair 
   2. Manual transmission and transaxle 
      1. Seal and gasket leaks, inspection and replacement 
      2. Linkage adjustment and repair 
      3. Clutch adjustment and repair 
   3. Final drive 
      1. U-joint inspection and replacement
      2. CV-joint inspection 
   4. Axle shafts 
      1. Seals, inspection and replacement 
      2. Wheel studs, replacement 
4. Air Conditioning and Heating Systems 
   1. Air Conditioning 
      1. Theory and operation 
      2. Component inspection and adjustment 
   2. Heating 
      1. Theory and operation 
      2. Component inspection and adjustment 
5. Electrical Systems 
   1. Multimeter use
   2. Lights, wiring, and circuit diagnosis and repair 
   3. Battery testing, diagnosis, and replacement 
   4. Alternator testing, diagnosis, and replacement 
   5. Vehicle starting with jumper cables 
6. Suspension and Steering Systems 
   1. Shock absorbers inspection and replacement 
   2. Wheel bearing, inspection, service, and replacement  
   3. Steering and alignment inspection and diagnosis
   4. Tires - inspection and diagnosis of wear patterns 
   5. Tires - change, repair, and balance 
7. Engine Performance 
   1. Ignition system, inspection, and diagnosis 
   2. Fuel system inspection and diagnosis 
8. Automotive Hand Tools and Equipment 
   1. Proper use and storage of automotive hand tools 
   2. Hoist operation and safety 
   3. Use of drills, taps, and dies